Freezer not getting cold

The part(s) or condition(s) listed below for the symptom Freezer not freezing are ordered from most likely to least likely to occur. Check or test each item, starting with the items at the top of the page. My amana freezer and fridge stop getting cold.

Things in freezer seem fine. Turned out my freezer was frozen solid. Fix a freezer not freezing but still cold Dave Here.

They are also half melted when I dispense them from the ice maker. With this issue, this sounds like the freezer is not getting as cold as it should be. This is a common problem an luckily, an easy one to fix. So here are a few of the most common reasons your freezer might not be freezing, and how to correct the freezer not freezing issue. That part was working perfectly.

Freezer is not cold enough : Check the temperature setting. Assure that there is enough room for air flow in the freezer. Check for air flow restrictions in vents. You might not know if its.

This can result in your freezer not freezing properly. These coils can get dirty, and they will not transfer heat or cold very well. Sometimes the evaporator coils get frozen over and air can’t pass over them. If your freezer is full of frost, the air intake to the refrigerator could get iced over and blocked.

The evaporator fan motor draws cold air over the evaporator coils and circulates it throughout the freezer. To determine if the evaporator fan motor is defective, try turning the fan blade by hand. There are several ways to fix a Frigidaire refrigerator or freezer that is not cold enough that depend on the source of the problem. These include fixing the condenser coils, the evaporator fan motor and the temperature control thermostat.

If this occurs, the freezer may still get cold , while the refrigerator will not get cold. If a freezer is not cold enough, it could be due to a build up of frost on the coils of the freezer. This will prevent it from cooling properly.

Check the following: Check the temperature control settings: For Dial or Digital Readout Models, adjust your temperature control by one number higher for a cooler temperature setting. Refrigerator Not Cooling Enough. Thus, cold air will not blow in the unit, and the unit will not get cold. The most common fridge not cooling problem is a frost free failure. Remove the access panel in the freezer section to expose the evaporator coils.

The fan blade can also hit this frost and either. If one dial is in the freezer section and one is in the food section, the one in the freezer section is the cold control, and the one in the food section is the air door.

The Damper controls the amount of cold air that flows from the freezer section to the fridge section. If it is broken or stuck, the fridge may not get cold enough. If ice is built up on the coils, a hairdryer can assist in defrosting them. If this is the case, food does not get cold , and your power bill goes up because the freezer is running all the time.

Luckily, Frigidaire freezers come with adjustable leg levelers, making it easy for you to level your freezer and prevent this problem. Warm Water from Dispenser Drop-Down Door Microwave and Drawer Microwave Keep Warm Feature. My Fridge Is Clicking and Not Cooling. Since there is no ice showing in the freezer you may not know the controller is over defrosting, but if it is, then it is hard to keep the freezer box cold , because of operating to defrost too much.

Most modern fridges allocate capacity between the freezer and the rest of the box, with the freezer getting priority. GE side by side refrigerator freezer is not freezing or cooling properly. A wall of ice was flowing down the back of the freezer (unplugged refrigerator to defrost), but freezer is not freezing and refrigerator is not cooling properly. The cold control can be the cause for your refrigerator not cooling problem. This is the least likely of all the problems but happens sometimes.

Turn the control up all the way and tap on it. Get shopping advice from experts, friends and the community! SamsungLarry, thank you for the link but NO, nothing in the linked document helps. I hear it kick in and motor running but even with the temp turned all the way up its not working properly. If you’re up for doing a little bit of sleuthing on your own before you make a service call for a broken compressor, try this simple test to tell if your compressor is bad or not : Grab a flathead screwdriver, pull your fridge away from the wall, and unplug it.

Any of these problems can cause the freezer to not get the power it needs to run. Touch the frame around the door to see if it feels extremely cold , a symptom of. Since then, it cycles normally, but does not get nearly cold enough.

Everything in the freezer is melte and the fridge is cool, but not cold. To get a cold fridge you need all of these prior steps to happen: 1. The refrigerator has power. For most refrigerators) if the fan in the freezer is running, the cold control is on. I have a Kenmore fridge with the bottom freezer. It has been working just fine.

If the lights come on, your fridge has power.